Can a Procedure for the Growth of Single-layer Graphene on Copper be used in Different Chemical Vapor Deposition Reactors?

In the last decade, catalytic chemical vapor deposition (CVD) has been intensively explored for the growth of single-layer graphene (SLG). Despite the scattering of guidelines and procedures, variables such as the surface texture/chemistry of catalyst metal foils, carbon feedstock, and growth process parameters have been well-scrutinized. Still, questions remain on how best to standardize the growth procedure. The possible correlation of procedures between different CVD setups is an example. Here, two thermal CVD reactors were explored to grow graphene on Cu foil. The design of these setups was entirely distinct, one being a “showerhead” cold-wall type, whereas the other represented the popular “tubular” hot-wall type. Upon standardizing the Cu foil surface, it was possible to develop a procedure for cm²-scale SLG growth that differed only by the carrier gas flow rate used in the two reactors.     

Characterization of ZnO:AI films deposited by r.f.magnetron-sputtering at low temperature

Transparent conducting ZnO:AI thin films with good adhesion and Iow resistivity have been prepared on organic substrates and Coming 7059 glass substrates by r.f. magnetron-sputtering technique at Iow substrate temperature (25-210℃). Structural and photoelectric properties of the deposited films are investigated. The deposited films are polycrystalline with hexagonal structure and a preferred orientation with the c-axis perpendicular to the substrate. Only the (002) peak is observed.High quality films with resistivity as Iow as 1.0 x 10- 3Ω@ cm and 8.4 x 10- 4Ω@ cm, the average transmittance over 74% and 85% in the wavelength range of the visible spectrum have been obtained on different substrates.     

平面火花隙三电极开关研制及性能测试

 研制了一种适用于平行板传输连接的平面火花隙三电极开关，开关正负电极为半圆形状，触发电极为细条状。将之替代立体式（半球形电极）火花隙三电极开关并应用于爆炸箔起爆装置中，装置回路参数将得以优化。实验测试了空气间隙为4.12， 3.14和2.2 mm的平面火花隙三电极开关的性能。结果表明，在开关间隙间距一定的情况下，随着电压的升高，开关间隙的放电时延和分散时间呈指数降低，开关电感小于15 nH；对于不同范围内的应用电压，使用不同间隙间距的开关，其分散时间不大于10 ns。该开关应用于较低充电电压（小于10 kV）的脉冲功率装置中，与立体式火花隙三电极开关相比，回路电感降低了约50 nH，放电周期缩短近1/3，峰值电流增加约1/3。     

面心立方晶体外延膜沉积生长中失配位错的结构与形成过程

用分子动力学方法对5%负失配条件下面心立方晶体铝薄膜的原子沉积外延生长进行了三维模拟.铝原子间的相互作用采用嵌入原子法(EAM)多体势计算.模拟结果再现了失配位错的形成现象.分析表明，失配位错在形成之初即呈现为Shockley扩展位错，即由两个伯格斯矢量为〈211〉/6的部分位错和其间的堆垛层错组成，两个部分位错的间距、即层错宽度为1.8 nm,与理论计算结果一致；外延晶体薄膜沉积生长中，位错对会发生滑移，但其间距保持稳定.进一步观察发现，该扩展位错产生于一种类似于“局部熔融-重结晶”的表层局部无序紊乱- 关键词： 失配位错 外延生长 薄膜 分子动力学 铝     

Spectrofluorimetric Method for the Determination of Aluminum with Alizarin Red PS

 A simple and direct spectrofluorimetric method has been developed for the determination of aluminum using alizarin red PS (1,2,4-trihydroxy 9,10-anthraquinone-3-sulfonic acid). The method is based on the strong fluorescence (480/564 nm) of Al³⁺ and alizarin red. Experimental parameters such as pH, concentration of the ligand, ionic strength of the solution, reaction time and temperature were optimized in order to maximize the analytical signal. Interferences of several ions (anions and cations) were studied and evaluated. The linear range of the method extends from 3 to 100 μg L⁻¹. Limit of detection (3s_b) was 0.9 μg L⁻¹. The method was tested with a silicate certified reference material. Interferences were eliminated by a liquid extraction with cupferron. Author for correspondence. E-mail: aucelior@rdc.puc-rio.br Received September 10, 2002; accepted January 15, 2003 Published online May 5, 2003     

Luminescence properties of anodic aluminum oxide films with organic luminophores embedded into pores

Luminescence properties of porous anodic aluminum oxide films formed in a 0.6 M solution of citric acid and luminescence of paraterphenyl, perylene, coumarin 7, and rhodamine 6G dyes adsorbed by the films are investigated. The nature of emitting centers in anodic aluminum oxide is revealed. Intense photoluminescence of all tested dyes embedded into pores of anodic aluminum oxide has been found. A redshift of fluorescence spectra of dyes adsorbed by the matrix and emergence of an additional longwave band have been detected. Data obtained can be used in developing new thin-film luminescent coatings for future applications in optoelectronics and molecular electronics. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No 4, pp. 483–488, July–August, 1997.     

软X光辐射烧蚀实验方法研究

 用强激光辐照金箔靶，以金箔背侧软X光辐射为基础，提出了软X光辐射烧蚀研究的新靶型、新方法，做了C₈H₈样品辐射烧蚀初步实验。     

Mossbauer investigations of corrosion environment influence on Fe valence states in oxide films of zirconium alloys

Mössbauer investigations about iron atom redistribution in oxide films of zirconium alloys subjected to corrosion at 500°C in pure oxygen and water pair have been analysed. The alloys were also subjected to autoclave conditions at a pressure of 10.0 MPa and autoclave conditions at 350°C and at a pressure of 16.8 MPa, using distilled water and water with additives of lithium and fluorine. It is shown that, depending on the corrosion environment, various compounds of iron, such as α-Fe₂O₃, Fe₃O₄, and FeO, as solid solutions of iron in ZrO₂ are formed in oxide films.     

催化动力学光度法测定痕量铝

痕量铝在硝酸介质中能催化加速过氧化氢和高碘酸钾与二甲苯胺兰FF之间的褪色反应。研究了反应的最佳实验条件,建立了测定痕量铝的新方法。方法检出限为6.1×10-10gAl3+/mL,检测范围为0-1.0μgAl3+/25mL。本方法具有高灵敏度,选择性较好,操作简便,快速的特点。用以测定水样中的痕量铝,获得满意结果。